Elmer’s ‘Wobbler’ #25 part three
At this point I did a quick mock-up of all the parts and positioned the crank for transferring the hole position from the exhaust of the frame to the cylinder. Then after removing the indexer from the...
View ArticleElmer’s ‘Wobbler’ #25 part two
Once the pivot pin was turned down to the right size to be tapped M3, I then cut the M3 thread. You probably noticed that the tailstock is removed for this, I ran the lathe at the lowest speed ( I...
View ArticleElmer’s ‘Wobbler’ #25
Elmer's 'Wobbler' #25 The perfect choice for your first engine The choice of your first engine build project is critical and should follow the ‘KISS’ principle. Keep It Simple and Straightforward! Get...
View ArticleElmer’s Wobbler, a Turkish Delight
My name is Unal Kazak, I am not an engineer, but on the other side of the walk. I studied monumental sculpture and design. My interest to the metal workshop and model engineering is just a hobby, for I...
View Article
More Pages to Explore .....